![]() ![]() The minimum cubic inch capacity of the plaster ring that will be installed on the box is _ inch. A 4 11/16 × 11/4inch square metal box with a 2-gang plaster ring is to be installed as the box assembly. A separate equipment grounding conductor is not required for this installation. The wiring method used is 10 AWG wire installed in EMT. Remember: MC cable contains a grounding conductor! 2.0 Refer to the legend and partial wiring plan in Figure 116.201. Two 3" × 2" metal switch boxes will be ganged together to form a 2-gang switch box for the switches. The wiring method used is 12 AWG MC cable (with external connectors). 2 3/4 Refer to Figure 116.201, shown above. A 4 × 11/4 inch square metal box with a 2-gang plaster ring is to be installed as the box assembly. ![]() The wiring method used is 12 AWG wire installed in EMT. 6.75 Refer to the legend and partial wiring plan in Figure 116.201. Select N/A (not applicable) if there is not a Code reference for this. 200.7(C)(1) The Code section that specifies that white conductors in a cable assembly must be re-identified where used to "feed" a switch is _. "Weatherproof" and "GFCI protected" only A 125-volt, 15- or 20-ampere receptacle installed outside a house is required to be _. The Code reference(s) for this requirement is _. Theplans require that the outside receptacle for this dwelling be GFCI protected. The single-pole switch to the left of the sliding doors controls _. the exterior light fixture Refer to Figure 116.109. 70 The NEC® at 314.27(C) states that listed outlet boxes or outlet box systems that are listed and marked for the purpose shall be permitted to support ceiling-suspended fans (paddle type) that weigh _ pounds or less. 210.52(A)(2)(2) When determining the spacing between wall receptacles, the Code section that specifies whether or not the slidingpanels in glass doors in a dwelling are counted in the maximum spacing is _. not specified in the NEC® Along a wall line (not separated by doors), the maximum spacing between receptacles in the dining room in a cafeteria is _. arc-fault circuit interrupter (AFCI) The NEC® at Section 210.12 requires that _ protection be provided for all electrical outlets in residential bedrooms. 12 Along a wall line (not separated by doors), the maximum spacing between receptacles in the dining room in a house is _ feet. ![]()
0 Comments
Leave a Reply. |